Machine Types: Epilog Mini 18/24, Helix Tools needed: #1 & #2 Phillips head screwdrivers
Note: If you are printing through the Ethernet port it is important that you retrieve the parameter for the IP Address, Subnet Mask and Gateway from the old board before replacing it. To do so, please reference to the owner’s manual under section “Setting the IP Address on the Laser”. Don’t panic if your machine doesn’t boot up and you are unable to retrieve the parameters because we can get it from the computer. Give us a call after you complete installing the board, and we’ll walk you through getting the parameters.
If you have any questions, please contact Epilog’s Technical Support at the following:
Phone 303.215.9171Fax 303.531.7594email tech@epiloglaser.com