> Knowledge base> Article: The ADL-100 is not working with my Accent II. When I press "Laminate" the ADL-100 does not pick a d

The ADL-100 is not working with my Accent II. When I press "Laminate" the ADL-100 does not pick a disc.

Article ID: 45041 Print
Question
The ADL-100 is not working with my Accent II. When I press "Laminate" the ADL-100 does not pick a disc.

Answer

 

The ADL-100 is not working with my Accent II.  When I press "Laminate" the ADL-100 does not pick a disc.

1. Make sure the 6-pin mini-din cable is connected to both the Autoloader and the Accent II.

2. Make sure the laminate is loaded. 

3. Try a new roll of laminate.  The current roll may be defective.

4. Check the disc sensor on the Accent tray.  It could be stuck in the down position.  If so, it would be possible to laminate one at a time but not with the ADL-100 connected.  Usually, just nudging the sensor will get it working again.


related articles

Article Details
Views: 4295 Created on: May 25, 2014
Date updated: Jul 15, 2016
Posted in: Accent Laminator

Poor Outstanding