> Knowledge base> Article: How do I perform the Calibrate Last Disc procedure required for Bravo II firmware version 1.25 or hi

How do I perform the Calibrate Last Disc procedure required for Bravo II firmware version 1.25 or higher and Bravo XR or OptiVault firmware version 2.07 or higher?

Article ID: 44879 Email Print
Question
How do I perform the Calibrate Last Disc procedure required for Bravo II firmware version 1.25 or higher and Bravo XR or OptiVault firmware version 2.07 or higher?

Answer

How do I perform the Calibrate Last Disc procedure required for Bravo II firmware version 1.25 or higher and Bravo XR or OptiVault firmware version 2.07 or higher?

The Calibrate Last Disc (PC) or Calibrate One Disc Offset (MAC) utility is found below.  Simply download and run the PC utility to run the calibration.  For a Mac, first read the instructions and find the Calibrate One Disc Offset section, then run the utility as described in the manual.

Bravo II, XR, OptiVault - PC Calibration Utility
Bravo II/XR - MAC Calibration Instructions and Utility

Note: If you are upgrading from version 1.25 or higher to the current version this procedure is not necessary.  In other words, if you currently have a version lower than 1.25 and you are upgradinging to the current version you must perform this procedure.  If you are unsure what version you have, peform this procedure regardless.


related articles

Article Details
Views: 1671 Created on: May 24, 2014
Date updated: May 18, 2016

Poor Outstanding