> Knowledge base> Article: Labels are applied to the container crooked.

Labels are applied to the container crooked.

Article ID: 44949 Print
Labels are applied to the container crooked.



Labels are applied to the container crooked.

1. Check for container taper.  Some containers such as wine bottles may have a slight taper that will cause the label to be applied crooked.  You may be able to apply your label straight if you angle the container idler roller to correspond with the angel of the taper.  For example, if you normally apply labels to the bottle with both sides of the container idler roller in the third notch from the drive roller, try putting one side in notch three and the other side in notch four.

2. Roll Guides should also be positioned very close to the roll, but not squeezing any part of the roll (so the roll has very little play side-to-side between the guides).  The Roll Bar* also has some side to side movement which is normal but can be eliminated by placing a shim made of folded paper between the side frame and the edge of the Roll Bar*.

3. It may take several labels to allow the label stock to “straighten-out” or “settle-in” where it will run for the duration of the roll.  It will “settle-in” quicker if you make sure to get the label stock loaded relatively square to the roll.  Once the liner is locked into place you can make small adjustments by pulling on the left or right side of the liner.  You can see that your labels are square by making sure the edge of the next label off the roll is parallel to the Peel Edge*.  Once this is square adjust the roll and Roll Guides* to line up with that point on the roll.

4. For larger heavier rolls make sure that the roll is positioned on top of the Roll Guides with the magnetic portions facing in.  This will minimize the chances that the heavy roll will push the guides out of place.

5. For lighter rolls make sure the Roll Drag Arm* is in place as described in the manual.  If you do not have a Roll Drag Arm* please contact tech support.

6. The labels must be on a roll for application to work properly.  If they are not on a roll, attach them to another roll of the same size.

*Refer to page three of the manual if you need help indentifying any terms used in this article.

related articles

Article Details
Views: 5720 Created on: May 25, 2014
Date updated: Apr 12, 2016

Poor Outstanding