Epilog Knowledge Base - Support Center
Imagine. Design. Create.
Support Center > Knowledge base> Tagged: tube
Tag: tube
3 Articles
Orange arrow How do I align the laser beam of my Epilog Mini or Helix?

102429 views
  Aligning the Laser Beam of the Epilog Mini and Helix Machine Type: Mini 18 and 24 and Helix Laser Tools Required: # 1 Phillips Screw Driver 3/32 Hex (Allen) Wrench Target (supplied with machine) 1 piece of Masking Tape I need a new Target Order one by calling 303-215-9171, pressing #1 and r...
Tagged: align, laser, tube, mini, helix


Orange arrow How do I replace the laser tube in my Epilog Mini or Helix?

55240 views
  Laser Tube Replacement in the Epilog Mini and Helix Machine Types: Epilog Mini 18/24 and Helix Tools needed: Phillips head screwdriver #1 Turn off and unplug the laser system. Facing the back of the machine, remove the 9 screws using the Phillips head screwdriver on the back panel. The laser ...
Orange arrow How do I replace the laser in my Zing Laser?

23484 views
  Machine Type: Epilog Zing 16 and 24 Lasers Tools Required: #1 Phillips screw driver Lower the table to the bottom of the machine. Turn off the machine. Disconnect the machine from its power source. Remove the four Phillips screws which secure the left hand side panel. There are three ...
Posted in: Epilog Zing


Page: 1 of 1