Auto Focus Plunger Replacement on the Mini/Helix

Auto Focus Plunger Replacement on the Mini/Helix 

Machine Type:      Epilog Mini 18/24, Helix

Tools Needed:     

• Small screw driver
• 5/64 Allen wrench

Intro:

This procedure details steps to replacing the auto focus plunger on the Legend Mini and Helix machines. Before starting on this procedure, lower the engraving table a few inches and then turn off the machine. Please consult the exploded drawing of the X-carriage assembly for part names.

Procedure:

1. Remove the gray X-beam cover.
   
2. Remove the 5/64 hex screw from the Auto Focus plunger shaft.
   
   
3. Replace the auto focus plunger with a new plunger.
4. Put the Auto focus plunger into the spring and gently push up.
5. Tighten the 5/64 hex screw on the Auto focus plunger shaft.
   
   
6. Replace the gray X-beam cover.
   
   
   
   For a larger image of the exploded drawing of the X-Axis Carriage, click here.

If you have any questions, please contact Epilog’s Technical Support

Phone    303.215.9171
Fax       303.531.7594
E-Mail    tech@epiloglaser.com