> Knowledge base> Article: There is a label stuck or jammed in the feed area of my LX Series label printer. How can I remove it

There is a label stuck or jammed in the feed area of my LX Series label printer. How can I remove it and prevent it from happening again?

Article ID: 60614 Email Print
Question
There is a label stuck in the feed area of my LX Series label printer. How can I remove it and prevent it from happening again?

Answer

Removal:

Usually it is necessary to disassemble part of the printer to remove the stuck label.  This means the unit will need to come to Primera for factory service.  However, there are ways to remove these labels without taking apart the unit by using another larger synthetic (polyester, vinyl, BOPP) label.  You can use a larger synthetic label peeled off the liner and hand feed it through the feed area near the sensor.  Synthetic label stock is resistant to tearing and has very aggressive adhesive.  You can use it to “grab” the stuck labels.   This process works if you remove the small label within 24 hours - before the adhesive cures. Important Note:  Turn off the printer before attempting this procedure.  You do not want the printer to automatically feed this peeled synthetic label through the printer.  Instead you are using it as a tool to grab the jammed label. 

Prevention:

Some labels are more susceptible to jamming because of their shape and size.  Extremely small labels easily come off the liner because there is so little adhesive holding them in place.  However, any size label can become stuck inside the printer.  You can reduce the chance of labels coming off and jamming by doing the following:

1. Do not back feed labels through the machine by pressing “unload”.  You should always tear off any labels protruding from the front of the printer first.  Even if the labels are blank you can tear them off first and then tape them back onto a roll and feed them from the back.  The printer was only designed to feed labels consistently from back to front.  

2. Feed several labels in before starting to print by pressing the “load” button.

3. If you follow the guidelines above and you still consistently have stuck labels there may be a better way to design your label stock to prevent this.  For example, if you custom order your label stock you could have us “kiss-cut” the labels so that the waste is left on the roll and then put a black mark between each label on the back to sense the gaps.  This would eliminate this problem and also make it much easier to overbleed the stock.  Note: This method would not allow you to use an applicator unless you first manually stripped away the waste after you have printed. 

 


related articles

Article Details
Views: 2910 Created on: Jan 08, 2015
Date updated: May 10, 2017

Poor Outstanding