> Knowledge base> Article: The ADL-MAX is not picking discs from the printer tray after the Disc Publisher prints a disc.

The ADL-MAX is not picking discs from the printer tray after the Disc Publisher prints a disc.

Article ID: 45030 Email Print
Question
The ADL-MAX is not picking discs from the printer tray after the Disc Publisher prints a disc.

Answer

 

The ADL-MAX is not picking discs from the printer tray after the Disc Publisher prints a disc.

1. ADL-MAX Placement. You must Place the ADL-MAX on a flat surface with less than 1/16 inch sag.

Placing the ADL-MAX on an uneven surface may result in picking problems from the Disc Publisher printer tray.



If the ADL-MAX is on a flat surface try recalibrating the ADL-MAX to the Disc Publisher printing tray (see related article below) or try the following:

2. Manual Calibration of Pick Depth

1. Place one disc in the front bin on the left side of the ADL-MAX.
2. Hold the Pick and Sequence buttons until the lights flash.
3. While the lights are flashing push the Pick button.
4. Press the Pause or Sequence button 5 times.  You will hear the picker click each time.
---Pressing Pause causes the unit to pick lighter.  (If it is picking too deep, the tray will bend slightly as it picks.)
---Pressing Sequence causes the unit to pick deeper.
5. Press the Pick button to set the new pick depth.

Important Note: Even though this calibration is done for only one bin it will affect all ADL-MAX picking postions including the printer tray of the Disc Publisher.

Related Articles:

How do I calibrate the ADL-MAX bins. How do I re-calibrate the Disc Publisher tray and drive(s) to the ADL-MAX.


related articles

Article Details
Views: 2226 Created on: May 25, 2014
Date updated: May 19, 2016
Posted in: ADL-MAX

Poor Outstanding