> Knowledge base> Article: The LX800 will not print the last few labels of my label stock.

The LX800 will not print the last few labels of my label stock.

Article ID: 44870 Email Print
Question
The LX800 will not print the last few labels of my label stock.

Answer

The LX800 will not print the last few labels of my label stock.

It is normal for the LX800 to not print the last several inches of labels. The out of stock sensor prevents the end of the label stock roll from being fed through the printer. If the stock did feed through the printer, this could jam the print mechanism since the label stock is attached to the core with tape. Below is an explanation of how the sensor works:

Inside the LX800 there is a Loop Sensor underneath the label stock roll. It performs two functions: First, it maintains a Slack Loop beneath the roll. This prevents the label feed device from pulling on taut label stock which can cause the labels to slip. Second, it senses when the label stock is out. If the Loop Sensor detects label stock higher than the Loop Point it unrolls the stock until the sensor sees the label stock at or below the Loop Point. The Loop Sensor will always tell the Roll Arm to unwind label stock when it sees the label stock higher than the Loop Point until it reaches the Out of Stock point. At this point the LX800 will produce an out of stock message.

If you would still like to print on the last several labels, try this procedure:

  1. Leave the labels fed through the front of the printer and simply unroll the remaining label stock and tear it off the stock core. Be sure to remove any tape from the last label.
  2. Drape the remaining label stock from the first roll out the back of the printer. You will need to leave the lid open to accomplish this.
  3. Load a new roll of label stock. Remove the tape from the first label. (IMPORTANT - DO NOT TRY TO FEED THIS THROUGH THE FRONT!) The labels from the first roll will lay over the top of the new roll.

Using this procedure, the loop sensor will detect a roll of label stock while your last labels from the previous roll will feed over top of this new roll and through the printer.

Note: If Out of Stock is consistently occurring earlier, perhaps with several feet of labels remaining instead of several inches, then the loop sensor may need to be calibrated by a service technician.


related articles

Article Details
Views: 996 Created on: May 24, 2014
Date updated: Sep 28, 2016
Posted in: LX800-LX810

Poor Outstanding